JKS

Track Bar Relocation Bracket, Rear (BKWD-JKSOGS160)

ITEM# BKWD-JKSOGS160

Availability: IN STOCK

$64.95
Adding to cart… The item has been added
Note: Free shipping is only available when full cart value exceed’s $100.
SHARE ON SOCIAL MEDIA:
Get FREE Shipping on orders above $100
NEED ANY GUIDANCE?
Connect with an expert for your assistance.
WARNING: Products sold on this website can expose you to chemicals that are known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
  • Heavy-duty reinforcement bracket attaches directly to factory track bar mount on axle housing
  • Angled design corrects geometry on lifted vehicles with rotated axle housing or CV-type driveshaft
  • Premium steel construction is laser cut, formed and folded for maximum strength
  • Economical bolt-on solution minimizes risk of track bar failure on the trail
  • Protective powder coat finish resists corrosion
  • Correct Jeep Wrangler TJ or LJ rear suspension geometry with a JKS Rear Track Bar Relocation Bracket. The design compensates for improper track bar alignment / orientation after adjusting rotation of the axle housing. Requires at least a 3 inch suspension lift. Correction improves driveline angles after suspension has been lifted and a CV-type driveshaft installed. The heavy duty steel bracket attaches directly to factory track bar mount on your Jeep's axle housing. It relocates the mounting point 4.0 in. higher to reduce track bar operating angle and improve handling at speed. Eliminates binding and premature bushing wear. Minimizes risk of track bar failure. Protective powder coat finish resists corrosion.